技術指標：
測量范圍：-45℃～125℃
適用水深：40m（電纜長度依用戶需要配備)
電 源：支流4.5v、3節5號電池
功 耗：最大電流80mA
誤 差：0℃～40℃：最大誤差0.5℃
-45℃～125℃: 最大誤差2℃
分 辨 力：0.1℃
響應時間：自然水溫下不大于6秒 .
顯示：3位半LED顯示、小數點后1位 .

使用方法：
將傳感器放入水中欲測溫度位置、按下表殼上的按扭、數秒鐘后即可顯示所測溫度值 .

更換電池：
擰開后蓋上的螺釘、取下后蓋、即可按電池盒上的正負極安裝電池 .

注意：
電路板上的兩個電位器已標定好溫度計的精度、請不要?jiǎng)?.

This figure sham thermometer mainly used to measure temperature, can also be used to measure any non-corrosive medium temperature.

Measuring range can up to -45 ℃ ~ 125 ℃. The thermometer calibrate within 0 ℃ ~ 40 ℃.

Specifications:
1. Measuring range: -45 ℃ ~ 125 ℃
2. Apply depth: 40 m (according to user needs with cable length )
3. Power: tributary of 4.5 v, 3節on the 5th Battery
4. Power consumption: 80 mA maximum current
5. Error: 0 ℃ ~ 40 ℃: the greatest error of 0.5 ℃
-45 ℃ ~ 125 ℃: the greatest error of 2 ℃
6. Resolution: 0.1 ℃
7. Response time: natural water temperature of not more than six seconds.
8. Display: 3-LED display, one after the decimal point.

How to use:
Add to sensors will measure water temperature position, press the button on the case, after a few seconds to display the measured temperature.

The replacement of batteries:
After opening with a twist of the screws, remove the rear cover, according to the battery box is on the negative battery installed.

Note:
The two boards have potential for good thermometer calibration of precision, please do not move.